C-SCOPE SG-V Instruction Manual download pdf (Page 17)

There are three stages to the locating process; searching,

pinpointing and tracing

1. Turn the Mode Switch to the appropriate mode.

2. Hold in the On/Off trigger. The Locator should emit the audible

battery test tone and the digital display should come on. Check

the battery level indicator to confirm the batteries are usable.

3. Rotate the Sensitivity Control fully clockwise to its maximum

setting as indicated by the arrow on the control.

4. Carry out the search using a grid pattern as shown in the

diagram. Walk slowly and keep the Locator upright at all times

and stationary by your side.

5. As you approach the area in which there is a signal the

Locator will emit an audible response and show a visual

response on the display.

6. Keep walking until the audible and visual responses disappear.

Using the Locator: Searching

NOTE This search technique applies only to the

Power, Radio and

All

Scan modes. See ‘Using the

Generator/ Transmitter’ for the correct search pattern

when using Generator/ Transmitter Mode.

NOTE Sometimes the Locator will give an audible

response and strong (full scale) visual response across

the whole of the search area. In this case turn the sensitivity

down slightly and repeat the search using the same grid pattern.

Search Grid Pattern

cscopelocators.com

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 55 56

No comments

C-SCOPE SG-V Instruction Manual Page 17