C-SCOPE SG-V Instruction Manual download pdf (Page 35)

Pipe Tracing using a Sonde: Batteries

General Purpose Sonde

The General Purpose Sonde is supplied in two frequencies;

33kHz (orange casing) or 8kHz (green casing) and is

8kHz Sonde will only function with the MXL Locator.

1. To turn the Sonde on, separate the two halves of the

Sonde casing. Insert a new battery into the battery

compartment with the positive end down.

2. Screw the two halves of the Sonde together being

careful not to over tighten them. The Sonde is now

transmitting a signal.

3. To turn the Sonde off the battery must be removed

or reversed.

NOTE Only use alkaline batteries. Dispose of the used battery safely in accordance with local regulations.

NOTE Always use a new battery in a Sonde if you expect to take a long time to trace the pipe or duct route.

WARNING The Locator frequency MUST always be set to the same frequency as the Sonde.

-----

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 55 56

No comments

C-SCOPE SG-V Instruction Manual Page 35