C-SCOPE SG-V Instruction Manual download pdf (Page 22)

Using the Generator/ Transmitter: Batteries

Battery Check

Switch the Generator/ Transmitter on by pressing the On/Off switch. The Generator/ Transmitter should emit a loud

continuous tone or a regular pulsed tone. If the batteries need replacing an interrupted tone will be heard.

During use, the Generator/ Transmitter will also warn the Locator user of low battery status

by altering its normal continuous or pulsed signal output to a distinct interrupted signal output.

(SGV Generator and MXT Transmitter only:

Check the Battery Level Indicator in the bottom left hand corner of the

display. If there is only one segment or no segments of the indicator filled in

then the batteries will need to be renewed before locating work can begin.)

Changing the Batteries

 Remove the Accessory Tray.

 Undo the two round, knurled retaining screws situated on the

underside of the Generator/ Transmitter holding the Battery Cover.

 Remove ALL FOUR used batteries and replace with new ones.

 Be careful to insert the new batteries the correct way round in

the compartment as indicated on the case.

 Replace the Battery Cover being careful to not over tighten the

retaining screws.

 Replace the Accessory Tray.

WARNING Do not change batteries in confined spaces where gas may be present.

NOTE Dispose of the used batteries safely in accordance with local regulations.

NOTE Only use alkaline D (LR20) size batteries

Battery Levels

replace

batteries

SGV Generator and MXT Transmitter only

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 55 56

No comments

C-SCOPE SG-V Instruction Manual Page 22