C-SCOPE SG-V Instruction Manual download pdf (Page 28)

Generator/ Transmitter: Tracing the Direct Connected Signal

The tracing technique used to follow the Generator/

Transmitter signal when applied by a direct connection

method (Direct Connection Leads, Signal Clamp or Signal

Injector) is almost exactly the same as the normal tracing

technique used on Power, Radio or

All

Scan Modes but with

the following differences:

 The signal that the Locator is detecting will get weaker

the further away from the Generator/ Transmitter that

you go. It will be necessary to regularly adjust (increase)

the Locator Sensitivity Control to compensate for this.

 MXT Transmitter only:

Having traced the signal for a short distance it may be

worthwhile switching the MXT Transmitter to the

alternative frequencies to see if they give a stronger

response. Choose the frequency that gives the strongest

response and continue with the trace.

NOTE It is not possible to search for the signal above any leads connecting the Generator/ Transmitter

to the service or above the Earth Lead connected to the Earth Stake.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 55 56

No comments

C-SCOPE SG-V Instruction Manual Page 28